2

私が巨大な文字列を持っているとすると、1000行としましょう。そして、その文字列に「itext」のような名前を付けましょう。

そして、私は「Description:」という単語を含む「itext」の行にのみ興味があります。そして、たとえば、元の「itext」文字列の文字列「Description:」を含む行でのみ次の置換を行います。

regsub -all -- {Loopback} $itext "Lo" itext ;

これを達成する方法はありますか(行ごとに移動したり、分割したり、結合したりすることなく)?

たとえば、「itext」は次のようになります。

Loopback11 is up, line protocol is up 
Hardware is Loopback
Description: Loopback11-Eigrp-National
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, 
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/20036/0 (size/max/drops/flushes); Total output drops: 242246
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
159767635870 packets input, 108501870627241 bytes, 0 no buffer
Received 9361144 broadcasts (8029769 multicasts)
0 runts, 20036 giants, 0 throttles
20036 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
200041278050 packets output, 193147599625066 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
4

1 に答える 1

6

-line改行を区別するマッチングを有効にするオプションが必要なだけです。

regsub -all -line -- {^(Description:.*)Loopback} $itext {\1Lo} itext

http://tcl.tk/man/tcl8.5/TclCmd/regsub.htm

于 2012-10-15T01:27:48.893 に答える