0

ラボ 5.5.1 でパケット トレーサーで ccna3 を実行しています。質問は、2960 ルータでdebug spanning-tree eventsコマンドを実行するよう求めています。これは動作しません。すべてのルーターで STP がオンになっています。

下の画像は、ルート ブリッジを使用したスイッチのキャプチャです。このコマンドは 3 つのスイッチのいずれでも機能せず、このコマンドを 3 つすべてで実行するよう本に明確に書かれています。

どんな助けでも大歓迎です

S2#show spanning-tree 
VLAN0001
Spanning tree enabled protocol ieee
Root ID    Priority    32769
         Address     0001.643C.50E9
         This bridge is the root
         Hello Time  2 sec  Max Age 20 sec  Forward Delay 15 sec

Bridge ID  Priority    32769  (priority 32768 sys-id-ext 1)
         Address     0001.643C.50E9
         Hello Time  2 sec  Max Age 20 sec  Forward Delay 15 sec
         Aging Time  20

Interface        Role Sts Cost      Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Fa0/1            Desg FWD 19        128.1    P2p
Fa0/2            Desg FWD 19        128.2    P2p
Fa0/6            Desg FWD 19        128.6    P2p
Fa0/11           Desg FWD 19        128.11   P2p
Fa0/18           Desg FWD 19        128.18   P2p



S2#debug ?
ip       IP information
sw-vlan  vlan manager



S2#debug spanning-tree events
          ^
% Invalid input detected at '^' marker.
4

1 に答える 1